Suzuki AN400 Service Manual page 66

1A-3 Engine General Information and Diagnosis:
The possible cause of this indication is as follows:
Engine stop switch is in OFF position. Side-Stand/ignition inter-lock system is not working. Ignition fuse is burnt.
Dealer Mode
CAUTION
!
Before checking the malfunction code, do not disconnect the ECM coupler.
If the coupler from the ECM is disconnected, the malfunction code memory is erased and the
malfunction code can not be checked.
The defective function is memorized in the computer. Use the special tool's coupler to connect to the dealer mode
coupler (A). The memorized malfunction code is displayed on LCD (DISPLAY) panel. Malfunction means that the ECM
does not receive signal from the devices. These affected devices are indicated in the code form.
Special tool
(A): 09930–82720 (Mode select switch)
(A)
Malfunction
"NO"
"YES"
I705H1110111-01
(A)
I705H1110114-01
LCD (Display) Indication
C00
C** code is indicated from
small numeral to large one.
FI Light Indication
FI light turns OFF. For each 2 sec., code is
indicated.
I705H1110112-01
Indication Mode
—