Fuel Tank Heat Shield Construction; Fuel Cut Valve Removal And Installation - Suzuki AN400 Service Manual

1G-6 Fuel System:

Fuel Tank Heat Shield Construction

1
1. Fuel tank
2. Fuel tank heat shield

Fuel Cut Valve Removal and Installation

Removal
1) Remove the front box. Refer to "Front Box Removal
and Installation in Section 9D (Page9D-18)".
2) Disconnect the hose (1) and remove the fuel cut
valve (2).
"B"
2
"A": Match the upper end of the fuel tank heat shield with the flange base.
"B": Match the fuel tank heat shield with the R-edge.
B705H11706002
1
2
I705H1170026-04
"A"
1
2
Installation
Install the fuel cut valve in the reverse order of removal.
Pay attention the following points:
• Install the fuel cut valve with its protrusions "A"
engaged with cutaway "B" on the gasket.
CAUTION
!
Replace the gasket with a new one.
B705H11706026
I705H1170041-01
"A"
"B"
I705H1170001-02