Radiator Hose Removal And Installation; Radiator Reservoir Tank Removal And Installation; Cooling Fan Inspection - Suzuki AN400 Service Manual

1F-9 Engine Cooling System:

Radiator Hose Removal and Installation

Removal
1) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page0B-11)".
2) Remove the left footboard. Refer to "Footboard
Removal and Installation in Section 9D (Page9D-
21)".
3) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page1D-9)".
4) Remove the radiator mounting bolts. Refer to
"Radiator Removal and Installation (Page1F-7)".
5) Remove the required radiator hose.
Installation
Install the radiator hose in the reverse order of removal.
Pay attention to the following point:
• Rout the radiator hose properly. Refer to "Radiator
Hose Routing Diagram (Page1F-5)".
Radiator Reservoir Tank Removal and
Installation
Removal
1) Remove the front leg shield. Refer to "Front Leg
Shield Removal and Installation in Section 9D
(Page9D-14)".
2) Remove the reservoir tank bracket bolt.
3) Disconnect the hoses and remove the reservoir tank
(1).
4) Remove the bracket (2).
2
Installation
B705H11606030 Install radiator reservoir tank in the reverse order of
removal. Pay attention to the following point:
• Fill the reservoir tank to the upper level.

Cooling Fan Inspection

Inspect the cooling fan in the following procedures:
1) Remove the left footboard. Refer to "Footboard
2) Remove the under cover. Refer to "Under Cover
B705H11606007
3) Disconnect the cooling fan motor lead wire coupler
1
4) Test the cooling fan motor for load current with an
I705H1160015-01
I705H1160016-01
Removal and Installation in Section 9D (Page9D-
21)".
Removal and Installation in Section 9D (Page9D-
16)".
(1) and fan switch coupler (2).
1
ammeter connected as shown in the figure.
I705H1160018-05
B705H11606008
2
I705H1160019-01
I310G1160028-01