Suzuki AN400 Service Manual page 89

Troubleshooting
CAUTION
!
When using the multi-circuit tester, do not strongly touch the terminal of the ECM coupler with a
needle pointed tester probe to prevent the terminal damage or terminal bend.
NOTE
After repairing the trouble, clear the DTC using SDS tool. Refer to "Use of SDS Diagnosis Reset
Procedures (Page1A-15)".
Step
1 1) Turn the ignition switch OFF.
2) Remove the helmet box front cover. (Refer to "Helmet
Box Front Cover Removal and Installation in Section 9D
(Page9D-16)".)
3) Check the IAP sensor coupler (1) for loose or poor
contacts.
If OK, then measure the IAP sensor input voltage.
4) Disconnect the IAP sensor coupler.
5) Turn the ignition switch ON.
Action
1
Engine General Information and Diagnosis:
Yes
Go to Step 2.
I705H1110016-01
1A-26
No
• Loose or poor
contacts on the ECM
coupler (terminal (14)
or (4)). Refer to
"Terminal Alignment
of ECM Coupler
(Harness Side)
(Page1A-5)".
• Open or short circuit
in the R wire or B/Br
wire.