Specifications; Tightening Torque Specifications - Suzuki AN400 Service Manual

6B-11 Steering / Handlebar:
4) Do the same on the other grip end.
5) If the initial force read on the scale when the
handlebar starts turning is either to heavy or too
light, adjust it till it satisfies the specification.
a) First, loosen the front fork clamp bolts, lock-nut
and steering stem nut, and then adjust the
steering stem nut by loosening or tightening it.
b) Tighten the steering stem nut, lock-nut and front
fork clamp bolts to the specified torque and
recheck the initial force with the spring scale
according to the previously described
procedures.
c) If the initial force is found within the specified
range, adjustment has been completed.

Tightening Torque Specifications

Fastening part
Handlebar clamp bolt
Master cylinder bolt
Steering stem nut
Lock-nut
Handlebar holder set bolt
Handlebar holder clamp bolt
NOTE
The specified tightening torque is also described in the following.
"Handlebars Components (Page6B-1)"
"Steering Components (Page6B-5)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque Specifications in Section
0C (Page0C-7)".
NOTE
Hold the front fork legs, move them back and
forth and make sure that the steering is not
loose.

Specifications

Tightening torque
N⋅m kgf-m
23 2.3
10 1.0
30 3.0
30 3.0
23 2.3
55 5.5
I705H1620032-01
B705H16207001
Note
lb-ft
16.5 (Page6B-3)
(Page6B-3) /
7.0
(Page6B-4)
21.5 (Page6B-7)
21.5 (Page6B-8)
16.5 (Page6B-8)
40.0 (Page6B-8)