Suzuki AN400 Service Manual page 401

9) Install the movable driven pin (7) to the pin hole with
the grease lightly coated.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
10) Check that the movable driven face can move
smoothly.
7
11) Install the movable driven face seat (8).
12) Install the spring (9) and clutch shoe assembly (10)
to the movable driven face (6) and attach the special
tool.
13) Engage the pawl of special tool to the hole of the
clutch shoe plate.
Special tool
(A): 09922–31440 (Clutch spring
compressor)
(A)
I705H1510052-01
8
I705H1510053-04
6
9
10
I705H1510054-04
Automatic Transmission:
14) While the special tool handle is being turned in
slowly, engage two flats "D" on the end of movable
driven face with the same shaped hole "E" on the
clutch shoe plate.
"D" D
15) Check that the pawl on the special tool is securely
fitted into the hole on the clutch shoe plate and
tighten the clutch shoe nut (11) to the specified
torque.
Special tool
(B): 09920–31020 (Extension handle)
Tightening torque
Clutch shoe nut (a): 105 N·m (10.5 kgf-m, 76.0
lb-ft)
11
(a)
5A-15
"E"
I705H1510055-04
(B)
I705H1510056-04