Rear Brake Caliper Parts Inspection - Suzuki AN400 Service Manual

Assembly
Assemble the brake caliper piston (bottom side) in the
reverse order of disassembly. Pay attention to the
following point:
• When assembling, position the adjust nut so as to fit
to the seat inside the piston.
CAUTION
!
When installing the snap ring, use the utmost
care not to allow the internal parts to pop out.

Rear Brake Caliper Parts Inspection

Refer to "Rear Brake Caliper Removal and Installation
(Page4C-3)".
Inspect the following parts.
Brake Caliper Cylinder
Inspect the brake caliper cylinder sliding face and oil
seal groove for wear or other damage. If any damage is
found, replace the caliper with a new one.
Brake Caliper Piston
Inspect the brake caliper piston sliding face for any
scratches or other damage. If any damage is found,
replace the piston with a new one.
Brake Caliper Piston
I705H1430026-01
Inspect the brake caliper piston sliding face and oil seal
groove of the seal for wear or damage. If any damage is
found, replace the piston with a new one.
Inspect the adjust nut, spring or snap ring for any
scratches or other damage. If any damage is found,
replace the piston with a new one.
B705H14306008
I705H1430027-01
Rear Brakes: 4C-8
I705H1430028-01
I705H1430029-01