Tp Sensor Removal And Installation; Ect Sensor Inspection; Ect Sensor Removal And Installation; Speed Sensor Inspection - Suzuki AN400 Service Manual

1C-3 Engine Electrical Devices:

TP Sensor Removal and Installation

Removal
1) Remove the helmet box front cover. Refer to "Helmet
Box Front Cover Removal and Installation in Section
9D (Page9D-16)".
2) Disconnect the coupler and remove the TP sensor
(1).
1
Installation
Install the TP sensor in the reverse order of removal.
Pay attention to the following point:
• Adjust the position of the TP sensor. Refer to "TP
Sensor Adjustment (Page1C-2)".

ECT Sensor Inspection

ECT sensor is installed on the cylinder head. Inspect the
ECT sensor in the following procedures:
1) Remove the ECT sensor. Refer to "ECT Sensor
Removal and Installation (Page1C-3)".
2) Connect the ECT sensor (1) to a circuit tester and
place it in the oil (2) contained in a pan, which is
placed on a stove.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
3) Heat the oil to raise its temperature slowly and read
the column thermometer (3) and the ohmmeter.
If the ECT sensor ohmic valve does not change in
the proportion indicated, replace it with a new one.
3
B705H11306009
I705H1130003-03
B705H11306010
(A)
1
2
I705H1130004-01
Temperature sensor specification
Temperature
20 °C (68 °F)
50 °C (122 °F)
80 °C (176 °F)
110 °C (230 °F)
CAUTION
!
• Take special care when handling the ECT
sensor. It may cause damage if it gets a
sharp impact.
• Do not contact the ECT sensor and the
column thermometer with a pan.
4) Install the ECT sensor. Refer to "ECT Sensor
Removal and Installation (Page1C-3)".

ECT Sensor Removal and Installation

Removal
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page1D-9)".
2) Disconnect the coupler and remove the ECT sensor
(1).
1
Installation
Install the ECT sensor in the reverse order of removal.
Pay attention to the following point:
• Tighten the ECT sensor to the specified torque.
Tightening torque
ECT sensor: 12 N·m (1.2 kgf-m, 8.5 lb-ft)

Speed Sensor Inspection

Inspect the speed sensor. Refer to "DTC "C16" (P0500):
Speed Sensor in Section 1A (Page1A-36)".
Standard resistance
Approx. 2.58 kΩ
Approx. 0.77 kΩ
Approx. 0.28 kΩ
Approx. 0.12 kΩ
B705H11306011
I705H1130005-01
B705H11306012