Suzuki AN400 Service Manual page 152

1D-8 Engine Mechanical:
Installation
Install the engine in the reverse order of removal. Pay attention to the following points:
4
(a)
1. Crankcase
2. Collar
• Tighten the engine mounting nut (2) to the specified torque.
Tightening torque
Engine mounting nut (a): 93 N·m (9.3 kgf-m, 67.0 lb-ft)
• Tighten the cushion rod nut (3) to the specified torque.
Tightening torque
Cushion rod nut (b): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
• Make sure that the thread of axle shaft is clean from any greasy matter.
• Install the rear wheel. Refer to "Rear Wheel Assembly Removal and Installation in Section 2D (Page2D-9)".
• Tighten the rear axle nut to the specified torque.
Tightening torque
Rear axle nut: 120 N·m (12.0 kgf-m, 87.0 lb-ft)
• Install the exhaust pipe/muffler. Refer to "Exhaust Pipe / Muffler Removal and Installation in Section 1K (Page1K-
2)".
2
LH
3. Engine mounting bolt
4. Engine mounting nut
2
(a)
1
RH
: 93 N⋅m (9.3 kgf-m, 67.0 lb-ft)
: Apply grease.
3
(b)
I705H1140193-02
I705H1140194-02
3
2
I705H1140191-05