Suzuki AN400 Service Manual page 335

4) Remove the bearing (7) using the special tool.
Special tool
(C): 09913–70210 (Bearing installer set)
7
5) Remove the magnet (8).
Idle gear / Idle shaft
1) Remove the washers (1), snap ring (2) and idle gear
(3).
1
2
(C)
I705H1310014-05
8
I705H1310015-01
3
I705H1310018-01
Drive Chain / Drive Train / Drive Shaft:
2) Remove the snap ring (4) and idle shaft (5).
5
4
Final driven gear / Rear axle shaft
1) Remove the snap ring (1) and final driven gear (2).
2
2) Remove the snap ring (3) from the rear axle shaft
(4).
3A-5
I705H1310019-02
1
I705H1310016-01
4
3
I705H1310034-04