Starter Clutch Component; Starter Clutch Removal And Installation - Suzuki AN400 Service Manual

1I-9 Starting System:

Starter Clutch Component

1. One-way clutch
2. Starter driven gear

Starter Clutch Removal and Installation

Removal
1) Drain engine oil. Refer to "Engine Oil and Filter
Change in Section 0B (Page0B-9)".
2) Remove the muffler. Refer to "Exhaust Pipe / Muffler
Removal and Installation in Section 1K (Page1K-2)".
3) Remove the generator cover (1).
1
(a)
3. Starter idle gear
: Apply thread lock to thread part.
4) Remove the generator rotor and starter driven gear.
B705H11906009
Installation
Install the starter clutch in the reverse order of removal.
Pay attention to the following points:
• Install the generator rotor. Refer to "Engine Bottom
• Replace the generator cover gasket with a new one.
• Install the muffler. Refer to "Exhaust Pipe / Muffler
• Pour engine oil. Refer to "Engine Oil and Filter
I705H1190018-02
1
3
: 26 N⋅m (2.6 kgf-m, 19.0 lb-ft)
Refer to "Engine Bottom Side Disassembly in
Section 1D (Page1D-37)".
Side Assembly in Section 1D (Page1D-44)".
Removal and Installation in Section 1K (Page1K-2)".
Change in Section 0B (Page0B-9)".
B705H11906008
2
I705H1190017-01