Suzuki AN400 Service Manual page 383

3) Pull the brake-lock lever (4) one notch.
4) Tighten the brake-lock cable adjust bolt (5) by hand
until it contacts the holder (6).
5) Tighten the brake-lock cable lock-nut (7) to the
specified torque.
Tightening torque
Brake-lock cable lock-nut (a): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
Tightening Torque Specifications
Fastening part
Brake-lock cable lock-nut
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque Specifications in Section
0C (Page0C-7)".
4
7
(a)
6
5
I705H1440005-03
Specifications
N⋅m
10
6) Install the brake hose clamp.
7) Install the front box. Refer to "Front Box Removal
and Installation in Section 9D (Page9D-18)".
8) After installing, adjust the brake-lock. Refer to "Brake
System Inspection in Section 0B (Page0B-13)".
Tightening torque
kgf-m lb-ft
1.0 7.0
Parking Brake: 4D-8
I705H1440002-05
B705H14407001
Note
(Page4D-8)