Rear Suspension Mounting Bushing Removal And Installation - Suzuki AN400 Service Manual

1D-54 Engine Mechanical:
• Install the oil seal using the special tool.
Special tool
(E): 09913–70210 (Bearing installer set)
CAUTION
!
Replace the removed oil seal with a new one.
Rear Suspension Mounting Bushing Removal
and Installation
Removal
1) Separate the crankcase. Refer to "Engine Bottom
Side Disassembly (Page1D-37)" and "Engine
Bottom Side Assembly (Page1D-44)".
2) Using appropriate size steel tubes (1) and vise,
remove the rear suspension mounting bushing (2)
(LH and RH).
3
1. Steel tube 2. Bushing
(E)
I705H1140158-02
B705H11406063
I705H1140159-01
1
2
1
I705H1140160-01
3. Crank case
Installation
1) Using an appropriate side steel tube and vise, press
in the busing into the crankcase (LH and RH).
CAUTION
!
Bushing end "A" must be flush with the
crankcase surface.
2
1
2
1. Bushing
2) Assemble the crankcase. Refer to "Engine Bottom
Side Disassembly (Page1D-37)" and "Engine
Bottom Side Assembly (Page1D-44)".
I705H1140161-01
"A"
I705H1140162-05
2. Crank case