Suzuki AN400 Service Manual page 192

1D-48 Engine Mechanical:
Cam Chain Tensioner
• Install the cam chain tensioner (1) and tighten the cam
chain tensioner bolt (2) to the specified torque.
Tightening torque
Cam chain tensioner bolt: 23 N·m (2.3 kgf-m, 16.5
lb-ft)
• Tighten the cam chain guide bolt (3) to the specified
torque.
Tightening torque
Cam chain guide bolt: 23 N·m (2.3 kgf-m, 16.5 lb-
ft)
• Set the cam chain (4) onto the crankshaft.
Starter Idle Gear
• Install the starter idle gear (1) onto the starter idle gear
shaft (2).
1
Starter Driven Gear
• Install the starter driven gear (1) and key (2).
• Apply engine oil to the starter clutch mating surface.
1
2
1
4
3
I705H1140123-02
2
I705H1140124-01
2
I705H1140128-02
Generator Rotor
• Degrease the tapered portion "A" of generator rotor
and also the crankshaft "B". Use nonflammable
cleaning solvent to wipe off oily or greasy matter and
make these surfaces completely off oily or greasy
matter and make these surfaces completely dry.
"B"
• Install the generator rotor (1).
NOTE
Make sure to engage the starter clutch with
the starter driven gear.
• With the generator rotor locked, tighten the generator
rotor nut to the specified torque.
Tightening torque
Generator rotor nut: 160 N·m (16.0 kgf-m, 115.5
lb-ft)
1
"A"
I705H1140240-01
I705H1140129-01