Suzuki AN400 Service Manual page 390

5A-4 Automatic Transmission:
Clutch and movable driven face
1) Hold the clutch housing using the special tool and
remove the clutch housing nut (1) and remove the
clutch housing (2).
Special tool
(A): 09930–40113 (Rotor holder)
(A)
2) Remove the clutch shoe and movable driven face
assembly (3).
Installation
Refer to "Drive V-belt Inspection (Page5A-6)".
Install the V-belt type continuously variable automatic
transmission in the reverse order of the removal. Pay
attention to the following points:
Clutch and movable driven face
1) Assemble the clutch shoe, movable driven face
assembly and V-belt.
2
• Position the V-belt so that its arrow points
1
• Degrees the V-belt contact surface (pulley
I705H1510006-02
3
2) Fit the V-belt by compressing it and pushing open
the driven face assembly.
I705H1510007-02
Keep compressing the center of V-belt so as
not to open apart.
CAUTION
!
to the engine rotational direction.
face).
CAUTION
!
I705H1510066-01
I705H1510008-03