Final Gear Assembly Removal And Installation - Suzuki AN400 Service Manual

Final Gear Assembly Removal and Installation

Removal
1) Remove the drive V-belt. Refer to "Drive V-belt
Removal and Installation in Section 0B (Page0B-
11)".
2) Remove the oil level bolt (1).
3) Remove the oil drain bolt (2) and drain oil.
4) Remove the final gear cover bolts.
5) Remove the rear wheel. Refer to "Rear Wheel
Assembly Removal and Installation in Section 2D
(Page2D-9)".
6) Remove the final gear cover (3) along with the drive
shaft (4).
7) Remove the dowel pins (5) and washer (6).
8) Remove the final driven gear (7) and rear axle shaft
(8).
5
6
B705H13106002
1
2
I705H1310003-04
4
3
I705H1310004-02
8
7
I705H1310005-01
Drive Chain / Drive Train / Drive Shaft:
9) Remove the idle shaft (9).
10) Remove the washer (10).
Installation
Install the final gear assembly in the reverse order of
removal. Pay attention to the following points:
CAUTION
!
Apply engine oil to each gears and shaft part.
• Install the dowel pin to the case side.
• Install the final gear cover and drive shaft.
CAUTION
!
• Replace the O-ring with a new one.
• Care should be used not to allow the O-
ring to be come off when installing the
transmission cover.
3A-3
9
I705H1310007-01
10
I705H1310008-01
I705H1310009-01