Brake Fluid Replacement - Suzuki AN400 Service Manual

4A-5 Brake Control System and Diagnosis:
7) Close the air bleeder valve and disconnect the hose.
8) Fill the reservoir with brake fluid to the top of the
inspection window.
Tightening torque
Air bleeder valve (Front brake): 6.0 N·m (0.6 kgf-
m, 4.5 lb-ft)
9) Install the reservoir cap.
Rear Brake
Bleed air from the rear brake in the same manner as the
front brake.
Tightening torque
Air bleeder valve (Rear brake): 6.0 N·m (0.6 kgf-m,
4.5 lb-ft)

Brake Fluid Replacement

CAUTION
!
Handle brake fluid with care: the fluid reacts
chemically with paint, plastic, rubber
materials, etc.
Front Brake
1) Place the motorcycle on a level surface and keep the
handlebars straight.
2) Remove the brake fluid reservoir cap and
diaphragm.
3) Suck up the old brake fluid as much as possible.
4) Fill the reservoir with new brake fluid.
I705H1410023-01
BF: Brake fluid (DOT 4)
5) Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
I705H1410024-01
6) Loosen the air bleeder valve and pump the brake
lever until the old brake fluid flows out of the brake
system.
B705H14106020
I705H1410003-01
I705H1410002-03
I705H1410022-01