Fuel Drain Tray And Ftpc Valve Removal And Installation - Suzuki AN400 Service Manual

• When installing the fuel pump assembly, first tighten
all the fuel pump mounting bolts lightly and then to the
specified torque, in the ascending order of numbers.
Tightening torque
Fuel pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0
lb-ft)
• Tighten the fuel hose to the specified torque.
Tightening torque
Fuel hose mounting bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
Fuel Drain Tray and FTPC Valve Removal and
Installation
Removal
1) Remove the front box. Refer to "Front Box Removal
and Installation in Section 9D (Page9D-18)".
2) Remove the fuel tank filler cap (1) fuel drain tray (2)
from the fuel tank.
CAUTION
!
After the fuel drain tray has been removed,
the fuel cap should be fitted to the fuel tank.
I705H1170008-01
(a)
Installation
Install the fuel drain tray and FTPC valve in the reverse
order of removal. Pay attention the following points:
• The hose should be fitted on the black side "A" of the
I705H1170038-04
B705H11706019
3) Disconnect the hose (3) from the fuel cut valve.
2
1
4) Remove the FTPC valve (4) from the fuel drain tray.
4
FTPC valve.
CAUTION
!
When installing fuel drain, care should be
used not to cause tear or other damage.
"A"
Fuel System: 1G-9
3
I705H1170029-02
I705H1170009-01
I705H1170010-02