Clutch In / Stall Speed Inspection; V-Belt Type Continuously Variable Automatic Transmission Removal And Installation - Suzuki AN400 Service Manual

Clutch In / Stall Speed Inspection

Refer to "Automatic Clutch Inspection in Section 0B
(Page0B-19)".
V-belt Type Continuously Variable Automatic
Transmission Removal and Installation
Removal
Clutch cover
1) Remove the side leg shield. Refer to "Side Leg
Shield Removal and Installation in Section 9D
(Page9D-15)".
2) Remove the belt cooling duct (1) and outer clutch
cover (2).
1
3) Unfasten the clamp and remove the inner clutch
cover (3).
3
B705H15106001
B705H15106002
2
I705H1510002-01
I705H1510003-01
Automatic Transmission:
Movable drive face
1) Hold the fixed drive face using the special tools and
remove the fixed drive face nut and washer.
WARNING
!
• To prevent the fin from breakage or injury
from occurring due to inadvertent slipping,
engage the tool end with the side of pulley
securely and make sure the contact is on a
center area of the fin.
• Remove the drive face nut with pressing
the special tool to the drive face.
Special tool
(A): 09920–53740 (Clutch sleeve hub
holder)
(B): 09920–31020 (Extension handle)
2) Remove the fixed drive face (1).
1
3) Remove the V-belt (2) and remove the movable drive
face assembly (3) together with the spacer (4).
5A-3
(A)
(B)
I705H1510004-02
2
3
4
I705H1510005-01