Installation
Install the CKP sensor in the reverse order of removal.
Pay attention to the following points:
• Install the CKP sensor to the generator cover. Refer to
"Generator Removal and Installation in Section 1J
(Page1J-6)".
• Install the muffler. Refer to "Exhaust Pipe / Muffler
Removal and Installation in Section 1K (Page1K-2)".
• Pour engine oil. Refer to "Engine Oil and Filter
Change in Section 0B (Page0B-9)".
IAP Sensor Inspection
Refer to "DTC "C13" (P0105-H/L): IAP Sensor Circuit
Malfunction in Section 1A (Page1A-25)".
IAP Sensor Removal and Installation
Removal
1) Remove the helmet box front cover. Refer to "Helmet
Box Front Cover Removal and Installation in Section
9D (Page9D-16)".
2) Disconnect the coupler and screw.
3) Remove the IAP sensor (1).
1
Installation
Install the IAP sensor in the reverse order of removal.
TP Sensor Inspection
Refer to "DTC "C14" (P0120/H/L): TP Sensor Circuit
Malfunction in Section 1A (Page1A-30)".
TP Sensor Adjustment
Adjust the TP sensor in the following procedures:
1) Warm up the engine.
2) Remove the helmet box front cover. Refer to "Helmet
Box Front Cover Removal and Installation in Section
9D (Page9D-16)".
3) Remove the upper meter panel. Refer to "Upper
Meter Panel Removal and Installation in Section 9D
(Page9D-13)".
4) Connect the special tool to the dealer mode coupler.
Refer to "Self-Diagnostic Procedures in Section 1A
(Page1A-13)".
Special tool
B705H11306005
B705H11306006
5) Turn the special tool's switch ON.
6) If the TP sensor adjustment is necessary, loosen the
TP sensor mounting screw.
7) Slide the TP sensor and bring the line to the middle.
8) Tighten the TP sensor mounting screw.
I705H1130006-03
B705H11306007
B705H11306008
"A": Incorrect
9) Remove the special tool.
10) Install the removed parts.
Engine Electrical Devices:
(A): 09930–82720 (Mode select switch)
"B": Correct position
1C-2
(A)
I705H1130023-03
I705H1130007-01
I705H1130025-01
"C": Incorrect