Driven Face Inspection
Inspect the driven face surface for stepped wear. If any
defects are found, replace if with a new one.
Service Data
Clutch
Unit: mm (in)
Item
Clutch wheel I.D.
Clutch shoe thickness
Transmission
Unit: mm (in) Except ratio
Item
Primary reduction ratio
Reduction ratio
Secondary reduction ratio
Final reduction ratio
Drive V-belt width
Movable driven face spring free
length
Movable drive face roller O.D.
Drive/driven face ware
Tightening Torque Specifications
Fastening part
Clutch housing nut
Fixed drive face nut
Clutch shoe nut
NOTE
The specified tightening torque is also described in the following.
"Clutch Shoe / Movable Driven Face Components (Page5A-11)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque Specifications in Section
0C (Page0C-7)".
Movable Driven Pin Inspection
Inspect the movable driven pin for abnormal wear or
damage. If any defects are noted, replace the pin with a
new one.
I705H1510060-01
Specifications
Standard
160.0 – 160.2 (6.30 – 6.31)
3.0 (0.12)
Specification
1.000
2.200 – 0.839
2.214
2.666
25.1 (0.99)
150.0 (5.90)
26.00 – 26.16 (1.024 – 1.030)
—
Tightening torque
N⋅m
kgf-m
85
8.5
105
10.5
105
10.5
Automatic Transmission:
I705H1510061-01
B705H15107002
Limit
160.5 (6.32)
2.0 (0.08)
Note
24.1 (0.95)
142.5 (5.61)
0.4 (0.02)
B705H15107003
Note
lb-ft
61.5
(Page5A-5)
76.0
(Page5A-5)
76.0
(Page5A-15)
5A-17
—
—
—
—