Final Gear Disassembly And Assembly - Suzuki AN400 Service Manual

3A-4 Drive Chain / Drive Train / Drive Shaft:
• Tighten the final gear cover bolt (1) to the specified
torque.
CAUTION
!
Tighten the final gear cover bolts diagonally
and evenly.
Tightening torque
Final gear cover bolt (a): 22 N·m (2.2 kgf-m, 16.0
lb-ft)
• Tighten the oil drain plug (2) to the specified torque
and after filling oil through the level hole, also tighten
the level bolt (3) to the specified torque.
CAUTION
!
Replace the gasket washer with a new one.
Tightening torque
Oil drain plug (b): 12 N·m (1.2 kgf-m, 8.5 lb-ft)
Oil level bolt (c): 16 N·m (1.6 kgf-m, 11.5 lb-ft)
Final gear capacity (when replacing)
190 ml
1
(a)
I705H1310033-01
3
(c)
2
(b)
I705H1310010-01

Final Gear Disassembly and Assembly

Refer to "Final Gear Assembly Removal and Installation
(Page3A-3)".
Disassembly
Final gear cover
1) Remove the drive shaft (1) and O-ring (2) from the
final gear cover (3).
2) Remove the oil seal (4) using the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
(A)
4
3) Remove the bearing (5) and (6) using the special
tool.
Special tool
(B): 09921–20240 (Bearing remover set)
5
B705H13106003
2
1
3
I705H1310011-02
I705H1310012-01
(B)
(B)
6
I705H1310013-01