Turn Signal / Side-Stand Relay Inspection; Turn Signal / Side-Stand Relay Removal And Installation; Dimmer Switch Inspection - Suzuki AN400 Service Manual

9B-7 Lighting Systems:
License Light Bulb
Replace the license light bulb in the following
procedures:
1) Remove the lens by turning it counter clockwise.
2) Replace the license light bulb.
3) After finishing the license light bulb replacement,
reinstall the removed parts.

Turn Signal / Side-stand Relay Inspection

Refer to "Electrical Components Location in Section 0A
(Page0A-7)".
NOTE
Make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are
OK, the turn signal relay may be faulty; therefore,
replace the turn signal/side-stand relay with a new one.
Refer to "Turn Signal / Side-stand Relay Removal and
Installation (Page9B-7)".
Turn Signal / Side-stand Relay Removal and
Installation
Removal
1) Remove the meter panel. Refer to "Meter Panel
Removal and Installation in Section 9D (Page9D-
14)".
2) Remove the turn signal/side-stand relay (1).
I705H1920010-01
Installation
Install the turn signal/side-stand relay in the reverse
order of removal.

Dimmer Switch Inspection

Inspect the dimmer switch in the following procedures:
1) Remove the meter panel. Refer to "Meter Panel
Removal and Installation in Section 9D (Page9D-
I705H1920024-01
14)".
2) Disconnect the left handlebar switch coupler (1).
B705H19206019
B705H19206020
1
I705H1920042-01
B705H19206022
1
I705H1920025-01