Starter Clutch - Suzuki UY125 Service Manual

REASSEMBLY
• Reassemble the drive belt filter in the reverse order of disas-
sembly. Pay attention to the following points:
• Install the plate after aligning the cooling belt cover holes A
with the plate pins B.
• Apply grease to the new O-ring and install the duct 1.
* 99000-25010: SUZUKI SUPER GREASE "A"
#
Use the new O-ring to prevent oil leakage.

STARTER CLUTCH

INSPECTION OF STARTER CLUTCH OPERATION
Turn the starter clutch gear by hand in the direction of arrow as
shown and check that rotation is smooth. Also check that the
gear is locked when attempted to turn in the other direction.
If a large resistance is felt or noise occurs when turning the gear,
check the starter driven gear sliding surface for wear or damage.
If any abnormal condition is found, replace the starter clutch with
a new one.
DISASSEMBLY
• Remove the starter clutch gear.
• With the rotor held immovable, remove the starter clutch
bolts.
$ 09930-34980: Rotor holder
• Remove the starter clutch 1 from the rotor.
• Remove the plate 2.
http://mototh.com
ENGINE 3-45