Honda Civic Service Manual page 1056

I
1 7 .
Oisconnect the driver's airbag connector (see step
2 on page 23-21), f ront passenger's airbag
connector (see step 3 on page 23-21), andfront
passenger's seat belt tensioner connector (see step
5 on page 23-22).
Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-22). Do not
disconnect the special tool from dashboard wire
harness B.
Check resistance between the No.8 terminal and
t h e N o . 1 7 t e r m i n a l o f S R S u n i t c o n n e c t o r A ( 1 8 P ) .
T h e r e s h o u l d b e 2 . 0 - 3 . 0 Q .
SRS UNIT CONNECTOR
A (18P)
RED/WHT
i-4
\ l e l a ;
E a
2 3 5
6
1
10
1 l 1Z t 3 t 5 16
RED/BLU
Wire side of female terminals
ls the resistance as specitied?
YES Faulty SRS unit or poor contact at SRS unit
connector A (18P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 23-'1221.a
NO Open or increased resistance in dashboard
w i r e h a r n e s s B ; r e p l a c e d a s h b o a r d w i r e h a r n e s s
B , t
1 8 .
I
]
I
t o .
DTC 3-3: Short to Another Wire or Decreased
Resistance in Driver's Seat Belt Tensioner
SpecialTools Required
. SRS inflator simulator 07SAZ-T8401'1A
. SRS simulator lead C 07TM-S25011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (ll), and checkthatthe
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO-lntermittent failure, system is OK at this time,
Go to Troubleshooting Intermittent Failures {see
page 23-26).
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's seat belt tensioner 2P
connector (A) from the floor wire harness.
-T84011A
07TAZ-S25011A
5 . C o n n e c t t h e S R S i n f l a t o r s i m u l a t o r ( 2 0 c o n n e c t o r )
a n d s i m u l a t o r l e a d C t o t h e f l o o r w i r e h a r n e s s .
(cont'd)
23-49