Filename; Dprocessor - Analog Devices VisualDSP++ 3.5 Manual

Linker Command-Line Reference
Table 2-6. Linker Command-Line Switches – Summary (Cont'd)
Switch
-version
-warnonce
-xref filename
The following sections provide the detailed descriptions of the linker's
command-line switches.

@filename

Uses
filemname
circumvents environmental command-line length restrictions.
may not start with "
White space (including "newline") in

-Dprocessor

The
-Dprocessor
(architecture); for example,
The
-proc processor
replacement for the
get processor.
White space is not permitted between
entry is case sensitive and must be available in your VisualDSP++ installa-
tion. This switch must be used if no
line (see ). This switch must be used if the specified
-T
specify
ARCHITECTURE()
and the file causes an error.
.LDF
2-38
Description
Outputs version information and exits.
Warns only once for each undefined symbol.
Produces a cross reference (
as input to the linker command line. The
" (that is, it cannot be a linker command line).
linker
(define processor) switch specifies the target processor
-DADSP-BF535
command is recommended as a
-Dprocessor
. Architectural inconsistency between this switch
VisualDSP++ 3.5 Linker and Utilities Manual
ProjectName.xrf
serves to separate tokens.
filename
or
-DADSP-2191
command line to specify the tar-
and
-D processor
file is specified on the command
.LDF
for 16-Bit Processors
More Info
on page 2-48
on page 2-48
file) on page 2-49
switch
@
filename
.
. The architecture
file does not
.LDF