Mpmemory - Analog Devices VisualDSP++ 3.5 Manual

LDF Commands
LENGTH(length_number)
or
END(address_number)
Identifies the length of the memory segment (in words) or specifies
the segment's end address. When you state the length,
length_number
region or an expression that evaluates to the number of words.
When you state the end address,
address
•
WIDTH(width_number)
Specifies the physical width (number of bits) of the on-chip or
off-chip memory interface. The
whole number.

MPMEMORY{}

L
The
MPMEMORY{}
physical shared memory, such as Blackfin processors and
ADSP-2192-12 DSPs.
The
MPMEMORY{}
memory in a multiprocessor target system. After you declare the processor
names and memory segment offsets with the
linker uses the offsets during multiprocessor linking.
Refer to "MPMEMORY{}" on page 5-28
command.
MPMEMORY{}
3-32
is the number of addressable words within the
command is used with DSPs that implement
command specifies the offset of each processor's physical
VisualDSP++ 3.5 Linker and Utilities Manual
is an absolute
address_number
paramter must be a
width_number
command, the
MPMEMORY{}
for a detailed description of the
for 16-Bit Processors