Configure Power On Settings; Operating Manual For Xdc Series Power Supply - Xantrex XDC 10-600 Operating Manual

Operation
Power Supply Operation
Aux line B has been selected to be configured.
To configure Aux line B:
Step # Do This
1
2
3
4
Configure The Power ON configuration can be set with 4 options:
Power ON
•
Factory Preset: Where the Power ON output is reset to the original factory
Settings
levels.
These include: Output=OFF, V
•
Last Setting: Where the Power ON output is set to the same level as when it was
last powered OFF. This is useful for automatic recovery from short power
failures.
•
User Settings: Where the Power ON output is set to a stored setting that is
recalled from memory. See "Store User Settings" on page 77.
•
Auto Sequence: Where the Power ON output can be recalled from memory. See
"To edit the sequence's trigger source:Using Auto Sequencing" on page 96.
The output state also depends on the Power ON Output setting. The values listed
above are true only if the OUT ON? setting is Yes. Otherwise Output is off (unit in
Standby mode).
See "Recall Settings" on page 79 for settings affected by the Power ON feature.
Each of the 4 Power ON configuration options can be accessed from the Front Panel
menus or remotely through a set of digital commands. The procedures that follow
show how to use the Front Panel menus.
84
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Press repeatedly until the
desired option appears. For this
example, CV is selected.
ENTER
Press repeatedly until the
desired option appears.
Select either "Act High" (Active high
logic) or "Act Low" (Active low logic)
for the auxiliary lines. In this example,
Active Low is selected.
ENTER
You Will See
Cfg CV
Pol Act High
Pol Act Low
This setting is saved and the display
returns to its default operating mode.
=0, and I =0. (default configuration)
SET SET

Operating Manual for XDC Series Power Supply