Section 1. About The XDC Power Supply
Overview
The XDC Series of digital, programmable DC power supplies is designed for use in
OEM, ATE, burn-in, magnet charging, and other high power systems for a broad
range of applications. The XDC uses our newly developed digital technology which,
combined with "Soft Switching," provides superior performance and a high level of
user control through both front panel and remote interfaces.
•
Features
Digital processing for highly accurate control
•
Ten, 99-step auto sequences for easy bench-top programming of complex test
routines
•
Ten stored settings
•
Zero voltage (soft) switching for low noise output, improved efficiency and
higher reliability
•
Active Power Factor Correction (PFC) for lower input current draw and lower
current harmonic generation
•
Remote voltage sense with 5V line drop compensation
•
Automatic Voltage/Current mode crossover
•
Constant power mode
•
Seven load protection mechanisms
•
Alarms and messages for over- and under-programmed trip points
•
Auxiliary status lines for monitoring power supply conditions
•
Remote interlock and trigger ports
•
Selectable standby, last setting, programmed sequence and other power-on
defaults
•
Active current sharing with parallel connected units for higher power
requirements*
•
Standard RS-232 remote control interface and optional GPIB (IEEE 488.2) port
•
CANbus communications link for multichannel addressing, and master/slave
current sharing*
•
Extensive SCPI command set
•
Keypad, knobs, and arrow keys for fast and tactile front panel operation
Release 3.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
21