Electrical Specifications; Driver Requirements; Mechanical Specifications; Performance Specifications - Xantrex XDC 10-600 Operating Manual

Electrical Specifications

Driver
IEEE 488.2 (Section 3.3).
Requirements
Table D.3Driver Types for Interface Lines
Signal
Line
DIO1
DIO2
DIO3
DIO4
DIO5
DIO6
DIO7
DIO8
Driver Specifications for 1 megabyte/second:
•
Low State: Output voltage
•
High State: Output Voltage (3 state)
The Output Voltage (open collector) is dependent on the composite Device Load
Requirements. The Voltage values are measured at the device connector between the
signal line and the logic ground.

Mechanical Specifications

Mechanical Specifications comply with IEEE 488.1 standards.
See Appendix E for details.

Performance Specifications

The power supply responds within 2 ms of receiving a command over the GPIB
interface.
Release 3.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Driver
Tri State
Tri State
Tri State
Tri State
Tri State
Tri State
Tri State
Tri State
<
+0.5V at +48mA sink current
Electrical Specifications
Signal
Driver
Line
EOI Tri State
DAV Tri State
NRFD Open Collector
(mandatory)
NDAC Open Collector
(mandatory)
REN Tri State
IFC Tri State
SRQ Open Collector
(mandatory)
ATN Tri State
≥
+2.4V at -5.2mA
GPIB
225