Store User Settings - Xantrex XDC 10-600 Operating Manual

Remote Operation
SCPI Commands for Digital Interfaces
Store User If you have a frequent or constant need for a specific voltage and current output, you
can save these setpoints in the power supply's memory as a user setting. Once a
Settings
setting is stored, it remains in the power supply's memory after the unit is powered
off.
See "Store User Settings" on page 77 for a list of parameters that are saved.
To store (save) settings:
*SAV <user-setting>
Example:
*SAV 1 will save all the present settings to user setting location 1.
To recall settings:
*RCL <user-setting>
To save default settings:
*SDS <user-setting>
This will save factory default settings to a user setting location, replacing any setting
that was previously saved there.
Example:
To save settings, set up the power supply with all required settings (we recommend
that you do this right after recalling the factory default settings).
For example, you can set voltage, current, and all protection levels.
Then to save the settings to Location 1: issue the command *SAV 1
When you want to recall the settings, issue the command *RCL 1. If you want to
recall them at the next power on, issue the command OUTP:PON:REC USER1
To recall last settings:
If you wish to recall the settings present when the supply was last powered off, send
the command:
SYST:REC:LAST
127
Release 3.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com