Select Remote Control Source - Xantrex XDC 10-600 Operating Manual

Select The REMOTE SELECT menu option allows you to select an interface for remote
control. Before selecting a remote control source, be sure to set up each interface
Remote
using the Remote Configure menu. See "Configure Remote Control Source" on page
Control
76
Source
Remote control sources are listed here along with their respective programming
interfaces:
•
RS–232
•
Analog V & I: Voltage and current programmed via the analog interface
•
Analog V: Voltage programmed via the analog interface; current
programmed via front panel
•
Analog I: Current programmed via the analog interface; voltage programmed
via front panel
•
GPIB
•
Multichnl: multichannel operation using the optional CANbus interface
between units (only available for 6000 Watt units)
To change the remote control source:
Step # Do This
1
2
3
4
5
If you change the remote setting to GPIB, the next time you shift from local to remote
control, the unit will shift to GPIB control.
Release 3.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MENU
4 times
ENTER
or
Press repeatedly until the desired
remote control source appears.
ENTER
Power Supply Operation
You Will See
ERROR MSGS
REMOTE SELECT
RS-232
The options are RS-232, Analog V &
I, Analog V, Analog I, GPIB, and RMT
linked.
The setting is saved and the display
returns to its default operating mode.
Operation
75