Xantrex XDC 10-600 Operating Manual page 114

Next select analog programming as the remote control interface.
Your options are
•
Analog V & I - voltage and current programmed via the analog interface
•
Analog V - voltage programmed via the analog interface; current set via front panel
•
Analog I - current programmed via the analog interface; voltage set via front panel
Step # Do This
1
2
3
4
5
Press the LCL/RMT button to begin remote operation via the analog interface.
SCPI
To select which setpoints to control via analog programming lines, use the
command:
SYST:REM:SOUR {AVOL|ACUR|AVC}
Where
•
AVOL (Analog VOLtage) selects only voltage to be programmed via the analog
programming lines
•
ACUR (Analog CURrent) selects only current to be programmed via the analog
programming lines
•
AVC (Analog Voltage and Current) selects voltage and current to be programmed
via the analog programming lines
To select the voltage level:
SYST:COMM:APR:LEV {5|10}
Where
"5" is the 0-5V range, and
"10" is the 0-10V range
To put the unit into remote control:
SYST:REM:STAT REM
Release 3.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MENU
4 times
ENTER
or
Select desired option.
ENTER
Remote Operation
Remote Analog Operation
You Will See
ERROR MSGS
REMOTE SELECT
RS-232
Analog V&I,
Analog V, or
Analog I
Setting is saved.
111