View Model Information; Default Display; View Power Output; Monitor Status - Xantrex XDC 10-600 Operating Manual

Operation

Default Display

View Model The MODEL INFO menu option displays hardware and software information
including:
Information
•
Manufacturer (Xantrex)
•
Model description (e.g. XDC 60–100)
•
Voltage and current ratings (60 V 100 A)
•
ROM version (e.g. ROM Ver. 5.000)
•
FPGA version (e.g. FPGA Ver. A007)
•
SCPI version supported (e.g. SCPI 1997.0)
•
Serial number
To access and work with the View Model Information option:
Step # Do This
1
2
3
Default Display
The default display normally shows the readback of the voltage and current output.
(To change the display to show voltage and power, or current and power, or voltage,
current, and power, see "Configure Display" on page 98.) The display also shows the
Regulation mode, CV, CC, or CP. Bar graphs represent the percentage of full
voltage, current, and power being output by the supply.
View Power To see the present power output in watts, press the Up arrow key. The output power
Output appears on the display. After a few seconds, the display shows the voltage and
current output again.
Monitor The front panel display has a large number of indicators and annunciators. See
Status "Display" on page 28 and "Status Annunciators" on page 28.
104
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MENU
1 time
ENTER
Press Up or Down arrow keys to
cycle through Model Information.
You Will See
ERROR MSGS
MODEL INFO
Xantrex
Operating Manual for XDC Series Power Supply