Multichannel Broadcast Commands; Specifications - Xantrex XDC 10-600 Operating Manual

Multichannel Add a suffix of "0" to simultaneously broadcast the "command" to the master and all
other units on the CANbus. Only commands are allowed, queries are not allowed.
Broadcast
Note that there will be a lag in execution time between the local unit and all other
Commands
units of up to a maximum of 20 ms. For example:
SOURCE0:VOLT 10.0
will set all units in a multichannel string to 10.0 V

Specifications

Max connected units
Max cable length
Bus speed
Termination
Connections
Addresses
Release 3.0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Multichannel Operation (6000 Watt only)
50
40 m
700 kbits/sec
120 ohm 1/4 W
parallel male DB9 to female DB9 cable
1 to 50
Remote Operation
117