Configure Current Share - Xantrex XDC 10-600 Operating Manual

Current Sharing (6000 Watt only)
Overview
Configure Current sharing may be configured either by SCPI commands sent via a remote
interface or by using the Front Panel. The current sharing modes available are:
Current
Share
•
No sharing
•
Master: sets up the unit as the master controller.
•
Slave: sets up the unit as the controlled slave.
Front Panel
In addition to selecting the current share mode, the master may be set up to display
the summed current from all units.
On the front panel, a MASTER or SLAVE annunciator will light up to indicate the
current share mode.
To configure current share with the front panel:.
Step # Do This
1
2
3
4
4a
174
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MENU
or Press 7 times
MENU
ENTER
or to select the current
share option (No share, Master or Slave).
Press to save.
ENTER
If No share or Slave are selected,
configuration is complete and the menu
exits.
If Master has been selected, you will be
prompted to select whether the master
should display the total current output of all
current share units.
Use or to select Y or N.
Press
ENTER
You Will See
ERROR MSGS
CURRENT SHARE
No share
Master
Display Sum? Y
Operating Manual for XDC Series Power Supply