Local Lockout (Llo) Command; Power Supply Settings; Table 2-11 Power Supply Settings - Xantrex ENET-XFR Operating Manual

Local Lockout (LLO) Command

Power Supply Settings

TM-XR9B-01XN
Use the Local Lockout command to disable the LOCAL button on the
power supply front panel. With LLO in effect, you cannot return to local
control by pressing the front panel LOCAL switch. You can still return to
local mode by sending the Go to Local (GTL) command. However, to turn
off LLO and return the power supply to local mode, send the REN OFF
command. Only the REN OFF command will remove the LLO condition.
Example:
LLO
GTL
REN OFF
For serial communication, the computer and the
Interface must share the same communication settings. Make sure that the
settings of the computer and of the power supply agree with those shown
in Table 2-11.

Table 2-11 Power Supply Settings

P a r a m e t e r
Transmission
Mode
Speeds
Parity
Connector
Start Bit
Stop Bit
Data Bits
Protocols
Set Local Lockout
Return the power supply to local mode.
Local Lockout is still in effect
Turn off Local Lockout and return the
power supply to local mode
S e t t i n g
Asynchronous
Full Duplex
75, 150, 300, 600, 1200, 2400, 4800, 9600 (default)
None
DB9-pin Male
1
1
8
XON/XOFF
RTS/CTS
NONE (default)
Power Supply Settings
Ethernet/RS-232
2–23