Table B.7 Commands For Fold Protection; Table B.8 Commands For Triggering; Table B.9 System Commands - Xantrex XDC 10-600 Operating Manual

Table B.7Commands for Fold Protection
Function SCPI Command
Set Output Fold Delay [:]OUTPut[<channel>]:PROTection:FOLD:DELay <delay>
Set Output Fold Mode [:]OUTPut[<channel>]:PROTection:FOLD[:MODE]
{NONE|CC|CP|CV}
Query Fold Protection [:]OUTPut[<channel>]:PROTection:FOLD:TRIPped?
Tripped
Table B.8Commands for Triggering
Function SCPI Command
Set Immediate Initiation of [:]INITiate[<channel>][:IMMediate]
Trigger System
Set Trigger Source [:]TRIGger[<channel>][:SEQuence]:SOURce
{BUS|EXTernal|IMMediate|NONE}
Table B.9System Commands
Function SCPI Command
Query System Error [:]SYSTem[<channel>]:ERRor[:NEXT]?
Recall Default Factory [:]SYSTem[<channel>]:RECall:DEFault
Preset
Select Remote Control [:]SYSTem[<channel>]:REMote:SOURce
Source {RS232|GPIB|AVOLtage|ACURrent|AVCurrent|MCHannel}
Set RS-232 Baud Rate [:]SYSTem[<channel>]:COMMunicate:SERial[:RECeive]:BAU
D {1200|2400|4800|9600|...}
Set RS-232 Flow Control [:]SYSTem[<channel>]:COMMunicate:SERial[:RECeive]:PAC
E {HARDware|XON|NONE}
Set Multichannel Address [:]SYSTem[<channel>]:COMMunicate:MCHannel:ADDRess
(6000 W only) <channel>
Set GPIB Address [:]SYSTem[<channel>]:COMMunicate:GPIB[:SELF]:ADDRess
<GPIB_address>
Set GPIB Power On [:]SYSTem[<channel>]:COMMunicate:GPIB[:SELF]:PONSrq
Service Request {ON|OFF|0|1}
Select Range for Analog [:]SYSTem[<channel>]:COMMunicate:APRogram:LEVel
Programming Interface {5|10}
Set Remote Control [:]SYSTem[<channel>]:REMote:STATe
Operation (Serial {LOCal|REMote|RWLock}
Interface)
Query SCPI Version [:]SYSTem[<channel>]:VERSion?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description Query
Set the delay time (seconds) before fold Yes
protection is triggered.
Select which regulation mode to fold back Yes
(None,CV, CC, CP)
Query if fold protection has tripped
N/A
Description Query
Initiate a triggered event or sequence N/A
Sets the trigger source for triggered Yes
setpoints
Description Query
Returns the next error in the instrument's N/A
error queue
Restore the factory preset values N/A
Select the remote control source Yes
Configure the RS-232 baud rate Yes
Select type of flow control for RS-232 Yes
Select the multichannel unit address Yes
Configure GPIB address Yes
Configure GPIB PON SRQ Yes
Select analog interface voltage levels Yes
RS-232 Only. Change remote control mode Yes
Returns the SCPI version to which the N/A
instrument complies. Format is YYYY.V