Select Remote Control Source - Xantrex XDC 10-1200 Operating Manual

Select Remote Control Source

The REMOTE SELECT menu option allows you to select an interface for
remote control. Before selecting a remote control source, be sure to set up each
interface using the Remote Configure menu. See "Configure Remote Control
Source" on page 3–20.
Remote control sources are listed here along with their respective programming
interfaces:
•
•
•
•
•
•
To change the remote control source:
If you change the remote setting to GPIB, the next time you shift from local to
remote control, the unit will shift to GPIB control.
TM-XDOP-01XN
RS–232
Analog V & I: Voltage and current programmed via the analog interface
Analog V: Voltage programmed via the analog interface; current
programmed via front panel
Analog I: Current programmed via the analog interface; voltage
programmed via front panel
GPIB
Multichnl: multichannel operation using the optional CANbus interface
between units
Step # Do This
1
MENU
2
4 times
3
ENTER
4
or
Press repeatedly until the desired
remote control source appears.
5
ENTER
Power Supply Operation
You Will See
ERROR MSGS
REMOTE SELECT
RS-232
The options are RS-232, Analog V
& I, Analog V, Analog I, GPIB,
and RMT linked.
The setting is saved and the display
returns to its default operating
mode.
3–19