External Interface Specifications - Epson AcuLaser C2600 Service Manual

EPSON AcuLaser C2600/2600

1.16.3 External Interface Specifications

The printer provides the following host interfaces.
USB interface (Rev. 2.0 HS, Supports bi-directional (D4))
Network interface (10Base-T/100Base-TX)
Parallel interface (IEEE1284)
Type-B interface
The locations of the respective interfaces are shown below.
Network Interface
Type-B Interface
USB Interface
Figure 1-8. Location of External Interfaces
Product Description
Parallel Interface
01001001
Controller Specifications
PARALLEL INTERFACE SPECIFICATIONS
Interface type: IEEE1284 bidirectional high-speed parallel interface
Operation mode: Compatibility, Nibble, ECP
Connector type name: 57RE-40360-830B (D7A) DDK or equivalent one
Compliant plug: Equivalent to AMPHENOLE
CMD: PJL, EJL, PCL, ESCPAGE-04, ESCPAGECOLOR-01, PCLXL, POSTSCRIPT,
Note *1: Hidden when operating in monochrome mode.
*2: Added when the PCL5C option DIMM is installed.
At the factory default settings, there are two types of MDL and DES which remain
unchanged even if the printer operating mode of the model is changed to color or to 1-
or 4-cartridge monochrome.
MDL for the color model is AcuLaser C2600 and for the monochrome model is
AcuLaser 2600.
DES for the color model is EPSON AcuLaser C2600 and for the monochrome model is
EPSON AcuLaser 2600.
USB INTERFACE SPECIFICATIONS
Universal Serial Bus Specification Rev.2.0 HS is supported.
USB model specific number: 33
When the printer is connected to the PC by the USB port, the interface does not support
D4. However D4 support is available if the EPSON external LAN option is connected.
The CMD of Device ID differs from the parallel interface with D4L3 being added.
Printer Name and Product Name are common to both AcuLaser C2600 and AcuLaser
2600.
CMD: PJL, EJL, PCL, ESCPAGE-04, ESCPAGECOLOR-01, PCLXL, POSTSCRIPT,
1, 2
PCL5C* * , D4L3
Note *1: Hidden when operating in monochrome mode.
*2: Added when the PCL5C option DIMM is installed.
Revision B
1, 2
PCL5C* *
41