Show Isis Adjacency - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
122 Confidential and Proprietary Information of ZTE CORPORATION

show isis adjacency

Use this command to display information about the current neigh-
bor.
All modes
show isis adjacency [level-1 | level-2| up_time {level-1 |
level-2}][vrf <vrf-name>]
level-1
level-2
up_time
vrf <vrf-name>
� If the VRF is configured, the adjacency information of the IS-IS
vpn instance will be displayed.
� If the up_time is configured, either level-1 or level-2 after
up_time should be configured.
� This example describes how to show the current neighbor in-
formation.
ZXR10#show isis adjacency
Interface
NPA
fei_1/1 0000.0a0a.0a0a
00:e0:63:06:05:c0
fei_1/2 0000.0a0a.0303 UP/UP
00:e0:63:0b:44:c0
fei_1/3 0000.0a0a.0505 UP/UP
00:e0:60:0b:06:c0
The displayed information is described below.
Field
Interface
System ID
Status
Level
Holds
SNPA
Priority
� This example shows how to show the up_time for current
neighbor.
ZXR10 (config)#show isis adjacency up-time level-1
Interface System id
The router is in area level-1
The router is in area level-2
The time that a neighbor has been up
VRF name, 1~16 characters
SystemID State
Priority
UP
64
L1L2
64/64
L1L2
64/64
Description
The name of the port.
The neighbor ID in the
xxxx.xxxx.xxxx format.
Including two formats: "UP" or "INIT"
Including three formats: "L1" "L2" or
"L1L2"
Hold time
The neighbor port address in the
<snpa type>xx.xx.xx.xx.xx.xx
format.
Election DIS priority
State Lev
Level Holds
L1 9 802.2
8/8 802.2
7/7 802.2
Holds Pri MT Time