Isis Lsp-Interval; Isis Ipv6 Metric - Zte ZXR10 8900 Series Command Reference Manual

Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
If the received packets are so long that all the content is not trans-
mitted, the configuration of this command will not act and the
length of packets will still be checked.
This example sets the interface to ignore the check of length of
packets.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis ignore-mtu

isis lsp-interval

Use this command to set the time interval of sending LSP packets.
Restore default with the no form of this command.
Interface configuration
isis lsp-interval <interval>[level-1 | level-2]
no isis lsp-interval [level-1 | level-2]
<interval>
level-1
level-2
If level-1 or level-2 is not specified, this command acts on both
level-1 and level-2 at the same time.
This example sets the time interval of sending LSP packets to 1
second.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis lsp-interval 1
ZXR10(config-intf)#isis lsp-interval 1 level-1
ZXR10(config-intf)#isis lsp-interval 1 level-2

isis ipv6 metric

Use this command to configure the metric value of IPv6.
Interface configuration
isis ipv6 metric <metric-value>[level-1 | level-2]
no isis ipv6 metric [level-1 | level-2]
<metric-value>
level-1
level-2
Confidential and Proprietary Information of ZTE CORPORATION
Time interval, unit: second, range: 1~65535,
default: 2 seconds
The router is in area Level-1
The router is in area Level-2
Metric value of the interface, range:
0~16777214
The router is in area Level-1
The router is in area Level-2
Chapter 4 IS-IS Protocol
109