Authentication-Type; Default-Information Originate - Zte ZXR10 8900 Series Command Reference Manual

Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
After the configuration of this command, the same authentication
password are set to snp packets at the same time. By default,
snp packets are also authenticated at the same time. Disable snp
packets' authentication with the command disable-snp-authent
ication.
This example configures LSP authentication of IS-IS.
ZXR10(config)#router isis
ZXR10(config-router)#authentication zte
ZXR10(config-router)#authentication zte level-1
ZXR10(config-router)#authentication zte level-2
enable-snp-authentication
disable-snp-authentication

authentication-type

Use this command to configure the authentication mode of LSP
packets of IS-IS. Delete the configuration with the no form of this
command.
Router configuration
authentication-type {MD5 | TEXT}[level-1 | level-2]
no authentication [level-1 | level-2]
MD5
TEXT
level-1
level-2
If no level-1 or level-2 is specified, this command will act on both
level-1 and level-2 at the same time.
The default authentication is TEXT.
This example configures the authentication mode of IS-IS LSP.
ZXR10(config)#router isis
ZXR10(config-router)#authentication-type MD5
ZXR10(config-router)#authentication-type MD5 level-1
ZXR10(config-router)#authentication-type MD5 level-2
ZXR10(config-router)#authentication-type TEXT
ZXR10(config-router)#authentication-type TEXT level-1
ZXR10(config-router)#authentication-type TEXT level-2

default-information originate

Use this command to configure the advertisement policy of the
default route. Delete the configured policy with the no form of
this command.
Confidential and Proprietary Information of ZTE CORPORATION
MD5 encryption authentication
TEXT authentication
Area Level-1 the router lies in
Area Level-2 the router lies in
Chapter 4 IS-IS Protocol
99