Passive-Interface; Redistribute - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
118 Confidential and Proprietary Information of ZTE CORPORATION

passive-interface

Use this command to configure an interface as a passive interface.
After that, the interface cannot send Hello packets, receive any
IS-IS packet or establish adjacent relationship with other routers.
Router configuration
passive-interface {default |<interface-name>}
no passive-interface {default |<interface-name>}
default
<interface-name>
The interfaces are passive ones by default.
If there is an interface which is the only one starting IS-IS, it can
be configured as passive-interface mode.
This example prevents routes from updating on interface fei_1/1.
ZXR10(config)#router isis
ZXR10(config-router)#passive-interface fei_1/1

redistribute

Use this command to configure the filtering policy for other proto-
col advertising routes to IS-IS. Cancel the redistribution with the
no form of this command.
Router configuration

redistribute

<protocol>[level-1|level-1-2|level-2][metric
<metric-value>][metric-type <type>][route-map <map-tag>]
no redistribute <protocol>
<protocol>
level-1
level-1-2
level-2
metric <metric-val
ue>
metric-type <type>
route-map
<map-tag>
Configures all the interfaces as passive
interfaces
Interface name
The specified route source, it can be connect,
static, rip, ospf, or bgp.
The router is in area level-1
The router is in area level-1-2
The router is in area level-2
Metric value of redistributed routes, range:
0~4261412864.
Metric type of redistributed routes, external
or internal, default: internal
Name of route map redistributed by current
protocol1~16 characters