Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
History Command
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
enable
disable-snp-authentication
Use this command to clear the authentication of SNP packets. The
enable-snp-authentication command is used to configure the
authentication of SNP packets.
Router configuration
disable-snp-authentication
By default, after the configuration of the authentication of LSP
packets, the authentication of SNP packets will be automatically
set.
This command is supported after the platform version 4.6.02.
This example describes clears the authentication of SNP packets.
ZXR10(config)#router isis
ZXR10(config-router)#disable-snp-authentication
enable-snp-authentication
The command no set-snp-authentication is adopted before the
platform version 4.6.02.
distance
Use this command to specify the priority of IS-IS routes. Restore
the default IS-IS route priority with the no form of this command.
Router configuration
distance <distance>
no distance
<distance>
This command acts on both level-1 and level-2 at the same time.
This example specifies the priority of IS-IS routes.
ZXR10(config)#router isis
ZXR10(config-router)#distance 120
enable
Use this command to restart IS-IS instances.
Confidential and Proprietary Information of ZTE CORPORATION
Priority of the IS-IS routes, range: 1~255,
default: 115
Chapter 4 IS-IS Protocol
101