Show Isis Topology - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
128 Confidential and Proprietary Information of ZTE CORPORATION
vrf <vrf-name>
When routers are gracefully restarting, this command can be used
to look over parameters of relevant status.
This example describes how to display parameters of status related
with current graceful restart of IS-IS.
ZXR10#show isis nsf
IS-IS NSF information:
NSF is ENABLE
NSF mode is Normal
NSF L1 active interface: 1
NSF L2 active interface: 1
NSF L1 T2 remaining: 20 seconds
NSF L2 T2 remaining: 20 seconds
NSF T3 using Adjacency
NSF T3 remaining: 10 seconds
Interface:fei_1/1
NSF L1 restart state: restart
NSF L1 helper in restart state: Other
NSF L1 T1 remaining: 5 seconds
NSF L1 T1 retransmissions: 1
NSF L2 restart state: restart
NSF L2 helper in restart state: Other
NSF L2 T1 remaining: 5 seconds
NSF L2 T1 retransmissions: 1

show isis topology

Use this command to display current IS-IS topology.
All modes
show isis topology [level-1 | level-2][vrf <vrf-name>]
level-1
level-2
vrf <vrf-name>
This example describes how to display current IS-IS topology.
ZXR10#show isis topology
IS-IS paths to level-1 routers
System Id Metric Next-Hop
0000.0000.0002 10
0000.0000.0005 --
0000.0000.0053 10
The displayed information is described below.
VRF name, 1~16 characters
The router is in area level-1
The router is in area level-2
VRF name, 1~16 characters
Interface
0000.0000.0002 fei_1/2
0000.0000.0053 fei_1/2
SNPA
0000.0c03.6bc5
0060.3e58.ccde