Zte ZXR10 8900 Series Command Reference Manual page 83

� If the OSPF protocol has already been started, the displayed
information is as follows:
ZXR10#show ip ospf
OSPF Router ID 200.1.1.1 enable/disable
Number of areas 2. Normal 2, Stub 0, Transit 1
Number of interfaces 5
Number of neighbors 5
Number of virtual links 8
Total number of entries in LSDB 20
Number of ASEs in LSDB 10. Checksum Sum 0x0
Number of new LSAs received 10
Number of self originated LSAs 10
Area 0.0.0.1 enable/disable
//It is a stub area/It is a stub area, no summary LSA
//Metric for default route 5
Area has no authentication/Area has simple password authentication
Times spf has been run 5
Number of interfaces 1. Up 1
Number of ASBR local to this area 2
Number of ABR local to this area 2
Total number of intra/inter entries in LSDB 20. Checksum Sum 0x0
Area ranges count 2
100.1.1.0 255.255.255.0
110.1.1.0 255.255.255.0
The displayed information is described below.
Field
OSPF Router ID
enable/disable
Number of areas
Normal
Stub
Transit
Number of interfaces
Number
Number of neighbors
Number of virtual links
Total number of entries in
LSDB
Number of ASEs in LSDB
Number of grace LSAs
Checksum Sum
Number of new LSAs
received
Number of self originated
LSAs
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 OSPF Protocol
Description
Router ID of OSPF protocol
Status of the current OSPF process
(enabled or disabled)
Number of OSPF areas
Number of non-stub areas
Number of stub areas
Number of transmission areas
Number of OSPF interfaces
Number of OSPF neighbors
Number of OSPF virtual links
Total number of LSAs
Total number of ASE LSAs
Total number of grace LSAs
Sum of checksums of ASE LSAs
Number of new LSAs received
Number of LSA local router generates
73