Isis Psnp-Interval; Isis Restart - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description

isis psnp-interval

Use this command to configure the time interval of sending partial
serial number packets. Restore default with the no form of this
command.
Interface configuration
isis psnp-interval <interval>[level-1 | level-2]
no isis psnp-interval [level-1 | level-2]
<interval>
level-1
level-2
If level-1 or level-2 is not specified, this command acts at both
level-1 and level-2 at the same time.
This example sets the time interval of sending partial serial number
packets as 2 seconds.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis psnp-interval 2
ZXR10(config-intf)#isis psnp-interval 2 level-1
ZXR10(config-intf)#isis psnp-interval 2 level-2

isis restart

Use this command to configure parameters of graceful restart
function of IS-IS.
Interface configuration
isis restart {t1-retry <retry-timers>[level-1 | level-2]}|{t1-t
imer <interval>[level-1 | level-2]}
no isis restart {t1-retry [level-1 | level-2]}|{t1-timer [leve
l-1 | level-2]}
t1-retry
t1-timer
<retry-timers>
<interval>
level-1
level-2
Confidential and Proprietary Information of ZTE CORPORATION
Time interval, in seconds, range: 1~65535,
default: 3 seconds
The router is in area Level-1
The router is in area Level-2
Retry times of t1 timer
Time of t1 timer
Retry times of t1 timer, default: 3
Time interval in seconds, range: 1~65535,
default: 3 seconds
The router is in area Level-1
The router is in area Level-2
Chapter 4 IS-IS Protocol
113