Show Ip Rip Database; Show Ip Rip Interface - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
10.0.0.0 0.255.255.255

show ip rip database

Use this command to show the route entries generated by the RIP
protocol.
All modes
show ip rip database [vrf <vrf-name>][network <ip-address
>[mask <net-mask>]]
vrf <vrf-name>
network <ip-addre
ss>
mask <net-mask>
This command is disabled by default.
According to the output information of this command, users can
make sure whether the current RIP routing table is correct.
This example displays the route entries generated by the protocol
of RIP.
ZXR10#show ip rip database
Pref Routes
h : is possibly down,in holddown time
f : out holddown time before flush
*> 10.0.0.0/8
*> 150.1.1.0/24
*> 160.1.1.0/24
*> 201.1.1.0/24
*> 203.1.1.0/24

show ip rip interface

Use this command to display information about RIP interface.
All modes
show ip rip interface [vrf <vrf-name>]<interface-name>
vrf <vrf-name>
<interface-name>
Invalid
Show the information of the interface running RIP protocol.
Use this command to display the RIP information of the fei_1/1
interface.
Confidential and Proprietary Information of ZTE CORPORATION
VRF name, 1~16 characters
Number of network, in the form of dotted
decimal
Network mask, in the form of dotted decimal
VRF name, 1~16 characters
The name of the interface to start RIP
Chapter 2 RIP Protocol
25