Ip Rip Originate Default Route; Ip Rip Receive Version - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
18 Confidential and Proprietary Information of ZTE CORPORATION

ip rip originate default route

Use this command to generate a default route on the interface and
force the advertisement of it. Disable this feature with the no form
of this command.
Interface configuration
ip rip originate default route [only]
no ip rip originate default route
only
This command is disabled by default.
Generate a default route on an interface and force to advertise it.
However, this default route is not added into the routing table of
the local router.
This example describes how to generate and force to advertise a
default route on the interface fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip originate default route
ip rip notify default route

ip rip receive version

Use this command to specify the RIP version which is received on
the interface. Restore the status of global version configuration
with the no form of this command.
Interface configuration

ip rip receive version [1 | 2]

no ip rip receive version
1
2
It depends on the version command. If the version command
is not configured, the default value will be used, that is, versions
both 1 and 2 are received.
This command can be used to ignore the RIP default status spec-
ified by the version command, but this only applies for the con-
figured interfaces.
The interface fei_1/1 only receives the packets of RIP version 1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip receive version 1
Only the default route is sent on this interface
The interface only receives the RIP packets
of version 1
The interface only receives the RIP packets
of version 2